Experimental Training Board has been designed specifically to study Digital time division multiplexing & demultiplexing. 8 channel Digital Multiplexer and Demultiplexer are provided on the Trainer. A rolling Address Generator scans the 8 channels sequentially. Data Generator with 8 different outputs act as signal sources for the 8 channels.
Practical experience on this board carries great educative value for Science and Engineering Students.

Object:
To study Digital Time Division Multiplexing & Demultiplexing.

Features:
The board consists of the following built-in parts :
01. ± 5V D.C. at 100mA IC regulated power supply internally connected.
02. 8 : 1 Multiplexer.
03. 1 : 8 Demultiplexer.
04. 8 bit Data Generator.
05. Clock & Address Generator.
06. Mains ON/OFF switch, fuse and jewel light.
* The unit is operative on 230V ±10% at 50Hz A.C. Mains.
* Adequate no. of patch cords stackable from rear both ends 4mm spring loaded plug length ½ metre.
* Good Quality, reliable terminal/sockets are provided at appropriate places on panel for connections /observation of waveforms.
* Strongly supported by detailed Operating Instructions, giving details of Object, Theory, Design procedures, Report Suggestions and Book References.

Other Apparatus Required:
* Dual Trace Cathode Ray Oscilloscope 20MHz.

Ltekonline are the manufacturers of Digital Time Division Multiplexing and Demultiplexing (TDM) Trainer used to demonstrate engineering principles in Engineering Colleges, Engineering Schools and Communication System for Engineering Teaching Lab in Universities