Tenders Description & Specification for Electrical Laboratory Equipment Instrumentation Training kit
Electrical Laboratory Equipment Instrumentation Training kit
The electronic training device, including the basic electrical experimenter, includes a host and a template unit. The host unit includes various measuring instruments, waveform generators, and power modules; the template unit has eleven templates each containing an eight-digit DIP switch, so the experiment on each template can use this switch to arrange appropriate faults. Let students practice troubleshooting. See Appendix 1 for the relative position of the fault repair switch. The fault switch of each template is factory-based, based on the principle that the circuit works normally. Place the switch in the normal position after troubleshooting.
Technical Parameters:
Input power: two-phase three-wire system 220V±10% 60Hz
Weight: Around <50kg
Training Kit including Installation, Commissioning and Testing Kits consisting of the following modules:
Temperature Regulator with PID controller
Filter (Low-pass filter with switchable time constant)
Integrator and Differentiator with switchable time-constant
Voltage/Frequency and Voltage/Current converters
Operating voltage: 230V (50 Hz)
Comparator with switchable hysteresis
Amplifiers with gain and offset control (Current amplifier, Summing amplifier, Differential amplifier, Instrumentation amplifiers )
Thermal Sensors (Photoconductive cell, Phototransistor, Linear variable differential transformer- LVDT)
Buffers and Inverters
Ltekonline are the manufacturers of Electrical Laboratory Equipment Instrumentation Training kit used to demonstrate engineering principles in Engineering Colleges, Engineering Schools and Electrical Trainer Kit for Engineering Teaching Lab in Universities