Pressurisation of the manometers is facilitated by a hand pump. The circuit and manometer are attached to a support framework, which stands on the working top of the Hydraulics Bench. The bench is used as the source of water supply and for volumetrically calibrating each flow meter.

A flow control valve permits variation of the flow rate through the circuit. Pressure tappings are incorporated so that the head loss characteristics of each flow meter may be measured. These tappings are connected to an eight-tube manometer bank incorporating a manifold with an air bleed valve. The equipment consists of a Venturi meter, variable area meter and orifice plate, installed in a series configuration to permit direct comparison. 

Demonstration Capabilities:

Directly comparing flow measurement using a Venturi meter, variable area meter and orifice plate

Comparing pressure drops across each device

Calibrating each flow meter using the volumetric measuring tank of the bench.