Tenders Description & Specification for Heat Transfer in Forced Convection
Heat Transfer in Forced Convection
Objective:
Comparison Of Heat Transfer Coefficient For Different Airflow Rates And Heat Flow Rates
To Plot Surface Temperature Distribution Along The Length Of Pipe
To Determine Average Surface Heat Transfer Coefficient For A Pipe By Forced Convection
Utilities Required:
Table For Set-Up Support, control panel, instruction manual in English and other accessories
Electricity Supply: 1 Phase, 220 V Ac, 2 Amp
Technical Details:
Air Flow Measurement: Orifice Meter & Manometer
Control Panel Comprising Of
Digital Voltmeter: 0-300 Volt
Digital Ammeter: 0-2 Amp
Variac: 0-230 V, 2 Amps
Test Section : Horizontal, Externally Heated
Diameter: 28 Mm (Approx.)
Length: 400 Mm (Approx.)
Blower: Fhp Of Standard Makes
Heater: Nichrome Wire
Digital Temp. Indicator: 0-3000c, With Multi-Channel Switch
Temperature Sensors: Rtd Pt-100 Type
With Standard Make On Off Switch, Mains Indicator Etc.
Ltekonline are the manufacturers of Heat Transfer in Forced Convection used to demonstrate engineering principles in Engineering Colleges, Engineering Schools and Thermal Training Equipment for Engineering Teaching Lab in Universities
