The electronic training device, including the basic electrical experimenter, includes a host and a template unit. The fault switch of each template is factory-based, based on the principle that the circuit works normally. The host unit includes various measuring instruments, waveform generators, and power modules; the template unit has eleven templates each containing an eight-digit DIP switch, so the experiment on each template can use this switch to arrange appropriate faults. Place the switch in the normal position after troubleshooting. Let students practice troubleshooting.

Technical Parameters:

Input power: two-phase three-wire system 220V±10% 60Hz

Weight: Around <50kg

Training Kit including Installation, Commissioning and Testing

Kits consisting of the following modules:

Temperature Regulator with PID controller

Thermal Sensors (Photoconductive cell, Phototransistor, Linear variable differential transformer- LVDT)

Filter (Low-pass filter with switchable time constant)

Integrator and Differentiator with switchable time-constant

Buffers and Inverters

Comparator with switchable hysteresis

Amplifiers with gain and offset control (Current amplifier, Summing amplifier, Differential amplifier, Instrumentation amplifiers )

Voltage/Frequency and Voltage/Current converters

Operating voltage: 230V (50 Hz).