Tenders Description & Specification for Apparatus Study Of Lost Load In A Conduct
Apparatus Study Of Lost Load In A Conduct
The bench should allow the following educational holdings:
Demonstration and measuring the change in the resistance laws (coefficient of friction) governing laminar and turbulent flows
Study of laminar and turbulent flow regimes
Determination of the critical Reynolds number
Checking the Poiseuille equation and determining the viscosity coefficient water in laminar flow.
Technical specifications required:
The proposed bank must be compatible with the volumetric hydraulic bench
Tube Connected by means of flexible tubes to a water column manometer and a Portable digital manometer
Test tube, mounted on a base with a static pressure tap doubled each end.
The bench will allow the study of laminar and turbulent regions
A needle valve located downstream of the tube allow a precise flow
A constant level tank to provide may be up above the system hydraulic power supply to allow the test tube laminar
The lengths of tube before and after the Test section will be sufficient to avoid the influence of upstream and downstream disturbances on results.
For The turbulent regime, the device will be connected directly to the valve of a bench hydraulic power.
Length Of the test drive: 524 mm
Diameter Of test driving: 3 mm
Mobile digital -Manomètre: 0 to 20 m water column
Charge Provided by the float chamber 915 mm of water.
Height Of water manometer: 530 mm
Flow rate up 1.42 l / min nominal
Manual air-Pump mounted on the device
Frame folded sheet with scale on the front
Measuring master cylinder graduated
4 Feet under the machine’s frame for the upgrade.
Ltekonline are the manufacturers of Apparatus Study Of Lost Load In A Conduct used to demonstrate engineering principles in Engineering Colleges, Engineering Schools and Fluid Mechanics Teaching Equipment for Engineering Teaching Lab in Universities
